Netgear ProSafe FS752TS 48 Port 10/100 Stackable Smart Switch Information

Browse a category or products!

Home >> Networking >> Switches >> Netgear ProSafe FS752TS 48 Port 10/100 Stackable Smart Switch

Product Information

1355390

Netgear ProSafe FS752TS 48 Port 10/100 Stackable Smart Switch

NETGEAR''s ProSafe FS752TS deliver performance and scalability through a 4Gbps, dual-ring, resilient stacking architecture with the ability to mix and match to stack up to six units or 192 10/100 ports and manage them all at a single IP address. The non-blocking design of the switches deliver simultaneous, full wire-speed, low-latency throughput to all ports. Shipped ready to go straight out of the box, they deliver switching that''s easy to set up, stack-up and use.

Features

	Expansion Slots		(2 Total) SFP
	Manufacturer		Netgear, Inc
	Number of Ports		48
	Manufacturer Part Number		FS752TSNA
	Standard Warranty		Lifetime
	Input Voltage		110V AC 220V AC
	Input Voltage Range		100V AC to 240V AC
	Dimensions		1.7" Height x 17.8" Width x 8.1" Depth
	Fast Ethernet Port		Yes
	Manufacturer Website Address		www.netgear.com
	Weight		6.57lb
	Product Name		ProSafe FS752TS 48 Port 10/100 Stackable Smart Switch
	Product Type		Stackable Ethernet Switch
	Interfaces/Ports		48 x RJ-45 10/100Base-TX LAN 4 x RJ-45 10/100/1000Base-T

Tech Specs

	Flow Control		IEEE 802.3x (Full-duplex) Back Pressure (Half-duplex)
	MTBF		84000Hour
	Connectivity Media		Category 5 Twisted Pair 10/100/1000Base-T
	Manufacturer		Netgear, Inc
	Number of Ports		48
	Number of Expansion Slots		2
	Package Contents		ProSafe 48 Port 10/100 Stackable Smart Switch Rubber footpads Power cord Rack-mount kit Resource CD Installation Guide Warranty/Support information card
	Manageable		Yes
	Status Indicators		Unit: Power, Master, Stack ID Per Port: Link, Speed, Activity Per Gigabit Port: Link, Speed, Activity, Stack
	Manufacturer Part Number		FS752TSNA
	Management		IEEE 802.1Q VLAN (128 groups, Static or Dynamic) IEEE 802.1p Class of Service (CoS) Port-based QoS SNMP v1, v2c, v3 MIB II Ethernet Interface MIB Bridge MIB DHCP client Storm control for broadcast, multicast and unknown unicast packets Port-based ingress/egress rate limiting SNTP RMON group 1, 2, 3, 9 Private Enterprise MIB Port Mirroring Support Web-based configuration Configuration Backup/Restore Password Access Control Firmware upgradeable
	Additional Information		Network latency: Less than 20 microseconds for 64-byte frames in store-and-forward mode for 100 Mbps to 100 Mbps transmission. Addressing: 48-bit MAC address
	Expansion Slots		(2 Total) SFP
	Input Voltage		110V AC 220V AC
	Switching Method		Store-and-forward
	Standard Warranty		Lifetime
	Temperature		0 C (32.0 F) to 50 C (122.0 F) Operating -20 C (-4.0 F) to 70 C (158.0 F) Storage
	Input Voltage Range		100V AC to 240V AC
	Fast Ethernet Port		Yes
	Protocols		SNMP v1 SNMP 2c SNMP v3 LACP DHCP SNTP
	Humidity		90% Maximum Non-condensing Relative Humidity Operating 95% Maximum Non-condensing Relative Humidity Storage
	Manufacturer Website Address		www.netgear.com
	Layer Support		2
	Number of Stacks		6
	Dimensions		1.7" Height x 17.8" Width x 8.1" Depth
	Security Features		Port-based security by locked MAC addresses 801.x security
	Brand Name		Netgear
	Altitude		10000 ft Operating 10000 ft Storage
	Address Table		8K MAC Addresses per System
	Frequency		50 Hz or 60 Hz
	Product Line		ProSafe
	Certifications & Standards		IEEE: IEEE 802.3 IEEE 802.3u IEEE 802.3ab IEEE 802.3z IEEE 802.3x Electromagnetic Compliance: CE mark, commercial FCC Part 15 Class A VCCI Class A EN 55022 (CISPR 22) EN 55024 (CISPR 24) C-Tick Safety: CE mark, commercial CUL 60950 (Listed)/ EN60950 (Low Voltage Directive) RFC: RFC 1213 RFC 1643 RFC 1493 RFC 2131
	Power Consumption		15 W Maximum
	Weight		6.57lb
	Product Model		FS752TS
	Product Name		ProSafe FS752TS 48 Port 10/100 Stackable Smart Switch
	Interfaces/Ports		4 x RJ-45 10/100/1000Base-T 48 x RJ-45 10/100Base-TX LAN
	Product Type		Stackable Ethernet Switch
	Performance		17.6Gbps Bandwidth